Step 12A, Install Overlay Panels - GE ZISS480NXBSS Installation Instructions Manual

Installation Instructions
ISTEP 12AI INSTALL OVERLAY PANELS
b. .
D 46_
Install door panels:
• Open door to 90°. Remove the 6 Phillips head screws
from the door handle.
• Remove the handle. Retain all screws.
• Remove the 6 screws holding the trim, then lift off
the trim. Retain the screws.
• Slide the overlay panel into the door trim.
Dispenser Models Onlg:
• The dispenser controls protrude begond the face
of the freezer door. To avoid damage to the dispenser,
the trim at the top of the door should be removed.
• Remove the screws holding the top trim in place.
• Place the assembled freezer panel into the bottom
channel and slide into the hinge side trim.
• Reinstall the top trim piece with the screws.
• There are two sets of holes in the handle side trim.
Replace handle side trim by installing the original screws
in the REARscrew holes.
• Secure the handle to the door using the FRONT
screw holes.
• Follow the same procedures to install the opposite panel.
• Check to be sure the handles are evenlg aligned with
each other at the top. To adjust, loosen the handle
screws and slide up or down. Tighten the screws.
J
Haedle
Trim
Move
Forward
F0r3/4"
Panel
j DoorTrim
Refrigerator
Door
SuppliedHandle
Shownin Overlay
PanelPositioe
UseFrontHoles
to SecureHandle
UseRearHoles
to SecureTrim
16