Step 15, Connect Power; Step 16, Start Icemaker - GE ZISS480NXBSS Installation Instructions Manual

Installation Instructions
[STEP 15] CONNECT POWER, CLOSE
GRILLE PANEL
• Open the grill panel.
• Plug in the power cord (if necessarg) bg reaching
into the opening next to the water filter. If access is
too tight, remove the 2 screws holding the water
filter bracket and move aside. Plug in the power cord
and secure the bracket with the original screws.
\
MasterLight Electrical
Switches OutletAccess
• Check to make sure power to refrigerator is on
bg opening refrigerator door to see if interior lights
are on.
• The temperature controls are preset at 37°F for
the fresh food section and O°F for the freezer.
• Allow 24 hours to stabilize before making
adjustments.
[STEP 16] START ICEMAKER
\
I
/
Power
Switch
aker
FeelerArm
• Slide the switch to ON. The icemaker will begin
operation automaticallg.
• Be sure nothing interferes with the sweep
of the feeler arm.
• Discard the first full bucket of ice cubes.
• To turn the icemaker off, slide the switch to OFF.
[STEP 171 INSTALL TOEKICK
• Locate the supplied toekick (shipped taped to
the side of the refrigerator). Install with the 2 screws
provided, adjust to the desired height and tighten
the screws.
• A custom toekick can be installed to match
or complement the surrounding cabinetrg.
Use the supplied toekick as a template
to cut the shape.
Supplied T oekick
--]
%
1/4" or ThickerToekick
INSPECT FINAL INSTALLATION
Check door alignment
Stand back awag from the refrigerator to inspect
the final installation.
• Check to be sure the handles are evenlg aligned with
each other at the top. To adjust, loosen the handle
screws and slide up or down. Tighten the screws.
• Shipping or the addition of heavg door panels
mag have caused the doors to move slightlg out
of alignment.
"Door O utof
Afignmeet
IL_J
• If necessarg, the fresh food door mag be adjusted up
or down to align with the freezer door.
• Use a 5/16" wrench to adjust the hinge pin as shown.
19