Step 9A, Install Overlay Panels - GE Monogram ZIC360N LH Design Manual

Installation Instructions
[STEP 9A] INSTALL OVERLAY PANELS
Right hand models shown. Use the same instructions
for left hm_d models.
Handle
Trim
Move
Forward
For3/4"
Panel
- Use Front Holes
to Secure Handle
UseRearHoles
to SecureTrim
DoorTrim
Refrigerator
Door
Suppliedhandleshown in the
overlaypanelposition.
Install door and drawer panels:
• Open door to 90 °. Relnove the 4 Phillips head screws
ti'om the door handle.
• Remove handle. P,emin all screws.
• Remove 4 screws holding trim, lilt off trim.
Retain screws.
• Slide overlay panel into the door trim.
• There are two sets of holes in the handle side trim.
Replace handle side trim by installing the original
screws in the REAR screw holes.
• Secure the handle to the door using the FRONT screw
holes.
• Follow the same procedures to install the drawer panel.
Custom handles
If you are using custom handles, the handle must be
properly secm'ed to the panel betore sliding the panel
into the trim,
• The cabinet manufacturer will supply the custom
handle and hardware.
• Secm'e the door/drawer trim using both the FRONT
and I/EAR screw holes. Discard supplied handle.
15