Cancelling Direct Transmission - Kyocera KM-2560 Operation Manual

Cancelling Direct Transmission

Cancelling Transmission (Disconnection of Communication)
Cancelling Polling or Sub Address Bulletin Board Transmissions
OPERATION GUIDE
During direct transmission, to cancel communication during transmission,
press the Stop key on the operation panel or [Cancel] on the touch panel.
The originals that have been scanned are ejected, and the screen returns
to the send default screen. When originals remain in the document
processor, take them out.
When you cancel sending or receiving by disconnecting the telephone line
during communication, use the following procedure.
NOTE:
If the Dual FAX option is installed, disconnect the line currently
being used for communication.
1
Press the Status/
Job Cancel key.
2
Press [Device/Communication].
3
Press [Line Off] of
FAX Port 1 or FAX
Port 2 (option).
When the cancel
confirmation screen
appears, press
[Yes].
The line in
transmission is
disconnected.
To cancel a polling or sub address bulletin board transmission, delete the
polling transmission original saved in the polling box. For information on
how to delete the saved original, refer to Deleting Originals in a Polling Box
on page 4-61.
30/40/50 ppm model
Status
Scanner
Ready .
Printer
Ready .
Removable Memory
Not connected.
Format Remove
FAX Line 1
Receiving...
Line Off Manual RX
FAX
Log
Printing Jobs Sending Jobs Storing Jobs
Status
FAX Operation (Basic)
25/30 ppm model
Hard Disk
Memory Card
Not connected.
Format Printing list
FAX/i-FAX Check New FAX
Device/
Paper /Supplies
Communication
10/10/2007 10:00
3-15
3