Xerox DocuPrint 180 Message Manual page 143

XEROX DOCUPRINT 180 LPS MESSAGE GUIDE
OS2730 Requested task not found in system. Check and retry.
A command was requested that the system cannot perform, or a task
name was keyed in incorrectly.
Action 1. Verify the task name and enter it correctly.
2. If the message reappears, the task is not available on your
system.
OS2732 Command not allowed until printer is cycled down.
You have entered a command that cannot be processed until the
printer is inactive (cycled down).
Action Wait until the printer cycles down and then retry the command.
OS2733 Command not allowed while IOT is in service mode.
The command you have entered cannot be processed while the
printer is being serviced.
Action None.
OS2734 Command not allowed while in lockout mode.
You have entered a command that cannot be processed because the
system is in a lockout diagnostic mode.
Action None.
OS2737 Command not supported in this configuration.
The attempted command is not valid with this configuration.
Action Check and retry.
OS2740 JDE not found. Check and retry.
The JDE entered in the START command does not exist on the
system disk.
Action Reenter the START command with the correct JDE. (Refer to the
online chapter in your Xerox DocuPrint 180 LPS Operator Guide .)
OS2741 JDL not found. Check and retry.
The JDL entered in the START command does not exist on the
system disk.
Action Reenter the START command with the correct JDL. (Refer to the
online chapter in your Xerox DocuPrint 180 LPS Operator Guide .)
OS2745 Enter password for document.
"DocumentPassword" The correct password must be entered before
the job can be continued.
Action Key in the correct password.
OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-65