Installation & Testing - Hoover ACM16 Instructions For Use Manual

05651295.qxd 31-07-03
Remove the machine from the packaging - close to where it will finally
be positioned - and proceed as follows:
On the back of the machine
1) Remove the central screw A and side
screws B and pull out the transit bracket C
along with the red locator.
2) Tilt the machine forward and remove the
polystyrene spacers.
3 Cover the central hole using the cap
enclosed in the instructions bag.
4) Adjust the two feet at the front to level the
machine.
5) Tilt the machine forward and locate the
base panel by (1) removing the paper
backing from the adhesive tape, (2) locate
the base panel in the front of the machine,
(3) offer the base panel up to the base of
the washing machine and locate the two
push clips.
21:53 Page 6
Installation & testing
6