Hoover ACM16 Instructions For Use Manual page 7

05651295.qxd 31-07-03
Note: we recommend you keep the transit bracket and
screws to protect the machine for future transit.
The Manufacturers will not be responsible for any
damage to the machine caused by not following the
instructions relating to releasing the transit protection.
The user is responsible for all installation costs.
Connecting the fill hoses
This machine has inlet hoses with 19mm (3/4") threaded ferrules fitted to the ends
to attach between the threaded connector on the appliance and the water supply.
Only use the new hoses supplied to connect the machine and ensure that
the sealing washers are in place inside the hose connectors.
Do not re-use old hoses which are attached to existing installations.
Do not over-tighten the connections. Hand tight is sufficient.
Do not trap or kink the hoses.
1. Connect the elbow end of hoses to
the back of the machine: red
connector (for hot water) to the red
threaded inlet, the white connector
(for the cold water) to the white
threaded inlet.
2. Connect the straight end of the hoses
to the stop taps.
If the inlet hose's connection point is
changed, check that the 3/4" threaded
ferrule on the inlet hose is firmly
attached to the electrovalve connector.
21:53 Page 7
7
HOT
RED
COLD
WHITE