To Avoid Breakage - Kenmore 79041112200 Installation Instructions Manual

To avoid breakage: Do NOT handle or manipulate
the unit by the cooktop glass.
The counter-top around the cut-out should
be fiat and leveled
(see cross-hatched area in illustration 1).
Before installing the unit, measure the heights of the two (2)
cabinet sides (H1-4), front and back (see illustration 1) from
the floor to the top of the counter.
Level the range using the
four (4)leveling legs so
that the height from the
floor to the underside of
the cooktop glass frame
is greater than the tallest
cabinet measurement
by at least 1/16" (see
illustration 2).
Slide the unit into the cabinet. Make sure the center of
the unit is aligned with the center of the cabinet cut-out.
Remove the protective channels on each side of the
glass cooktop (if provided).
The metal flange under each side of the cooktop MUST be
placed over the cabinet countertop for proper unit support.
The glass cooktop should NOT directly touch the countertop i\
(see illustration 2) or could cause glass breakage voiding the i
warranty. Level the unit if needed.
Iflustration I
After the installation, MAKE SURE that the
unit is supported by the leveling legs NOT
by the cooktop.
Iflustration 2
To successfully
install the range,
the initial level
height from floor
to underside of
cooktop glass
frame should
be at least
1/16" taller than
cabinet sides as
measured in step
1.