To Avoid Breakage - Kenmore 79042603311 Installation Instructions Manual

To avoid breakage" Do NOT handle or manipulate the
unit by the cooktop.
The counter=top around the cut=out should be flat and leveled (see
hatched area on illustration 1).
Before installing the unit, measure the heights of the two (2) cabinet
sides (H1=4), front and back (see illustration 1 ) from the floor to the
top of the counter.
Level the range using
the leveling legs or
leveling device so that
the height from the
floor to the underside
of the cooktop frame is
greater than the tallest
cabinet measurement
by at least 1/!6" (see
illustration 2).
1 ½" Max,
(3.8 cm Max.
Shave Raised Edge
to Clear Space for a
311/J'min (80 cm) Wide
Cooktop.
H]
Illustration 1
Slide the unit into the cabinet. Make sure the center of the
unit is aligned with the center of the cabinet cut=out.
The metal flange under each side of the cooktop MUST be
placed over the cabinet countertop for proper unit support.
The cooktop should NOT directly touch the countertop (see
illustration 2). Level the unit if needed.
After the installation, MAKE SURE that the
unit is supported by the leveling legs NOT
by the cooktop.
Illustration 2
To successfully
install the
range, the initial
level height
from floor to
underside of
cooktop frame
should be at
least 1/16"
taller than
cabinet sides
as measured in
step 2.
5