Power Supply Kit; Access To Terminal Block & Grounding; Serial Plate Location; Electrical - Kenmore 79041112200 Installation Instructions Manual

Power Supply Cord Kit
The user is responsible for connecting the power
supply cord to the connection block located behind
the back panel access cover.
This appliance may be connected by means of
permanent "hard wiring"; flexible armored or
nonmetallic shielded copper cable (when local
code allow it) or by means of a power supply cord
kit.
NOTE: Electric Slide-in Range is shipped from
factory with 1 1/8" (2.9 cm) dia. hole as shown on
figure 4. If a larger hole is required, punch out the
knockout.
Risk af fire ar electrical shack
exists if an incarrect slze range cord kit is used,
the Installatlan Instructlans are nat fallawed, ar
the strain relief bracket is discarded.
For mobile homes, new installations or recreational
vehicles, use only a power supply kit designed for a
range at 125V/250V 50A recommended (minimum
40A). Cord must have either 3 (when local code
permits grounding through neutral) or 4 conductors.
Terminal on end of wires must be either closed loop
or open spade tug with upturned ends. Cord must
have strain-relief clamp.
Da nat laasen the nuts which
secure the factary-installed range wiring ta
termlnal black while cannectlng range. Electrlcal
failure ar lass af electrlcal cannectian may accur.
Access to Terminal Block &
Grounding Strap
I
cover daar
__ Figure 1
This appllance is manufactured
with the frame graunded by cannectian af a
graundlng strap between the neutral pawer
supply terminal and the frame, if used in USA,
in a new branch circuit installatlan (1996 NEC),
mabile hame ar recreatlanal vehlcule, where
lacaJ cade da not permit graundlng thraugh
neutral (white) wire ar in Canada; remave the
graundlng strap tram the frame and cut the
ather end, near the neutral terminal. Cannect
the appllance in usual manner.
Electrical Shack Hazard
* Electrical graund is required an this appliance.
* Da not cannect ta the electrical supply until
appliance is permanently graunded.
* Discannect pawer ta the circuit breaker or fuse
bax before making the electrical cannectian.
* This appllance must be cannected ta a
graunded, metallic, permanent wiring system,
ar a graundlng cannectar shauld be cannected
to the graunding termlnal ar wire lead an the
appffance.
Failure ta da any af the abave cauld result in a
fire, persanal injury ar electrical shack.
Serial Plate
Location
You witl find the model
and serial number printed
on the serial plate. The
serial ptate is located as
shown.
Remember to record the
serial number for future
reference.
Figure 2