Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Owner's Manual
Advertisement
Table of Contents
Related Manuals for Kenmore 790.71105892
Summary of Contents for Kenmore 790.71105892
- Page 1 flqo.@lo_l'_cil 4qo._lo¢/¢qq- _qo .4/g,osc_/ /\tto b\t¢_...
- Page 2 INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. If the information in this manual is not followed exactly, a fire or explosion result causing property damage,...
-
Page 3: Important Safety Instructions
IMPORTANT SAFETY Never leave children alone or unattended in the area where an appliance is in use. As children INSTRUCTIONS grow, teach them the proper, safe use of all appliances. Never leave the oven door open when range unattended. Installation of this range must conform with local codes or, in the absence of local codes, with the National... -
Page 4: Before Starting
Locate the Bracket Using the Template- (Bracket may Before Starting be located on either the left or right side of the range. Tools You Will Need Use the information below to locate the bracket For leveling legs and Anti-Tip Bracket: template is not available). - Page 5 Level and Position Range - Level range by adjusting the (4) leveling legs with a wrench. Note: A minimum clearanceof 1/8' is required between the bottom of the range and the leveling leg to allow room for the bracket. Use a spirit level to check your adjustments. Slide range back into position.
- Page 6 Gas connection for electric ignition models For an accurate pressure check have at least two (2) other Manual Flare Flexible Flare Union Pressure top burners burning. Be sure the gas supply (inlet) pressure Shutoff Union Appliance Adaptor Regulator is at leastone inch above specified range manifold pressure. Valve Conduit The gas supply pressure should never be over 14 _ water...
-
Page 7: Operation
Grounding Instructions The surface burner should light when gas is available to the top burner. Each burner should light within four (4) The power cord of this appliance is equipped with a 3- prong (grounding) plug which mates with a standard seconds in normal operation after air has been purged prong grounding... -
Page 8: Air Adjustment
7. Air adjustment Operation of Oven Burners The air shutter (adjustment) for each of the four top Oven Adjustments burners is located at the open end of the venturi tube and sets on the hood of the valve. Electric Ignition Burners Operation of electric igniters should be checked after range Should the air shutter need adjusting, rotate the air shutter... - Page 9 Standing Pilot Oven Burner To light the oven pilot, proceed as follows: Turn the oven thermostat knob to OFF. Remove oven bottom, see step 10 for instructions on removing the oven bottom. Light the oven pilot with a match. The oven pilot should burn with a stable flame...
-
Page 10: Model And Serial Number Location
Pressure Regulator location 12.Make Sure Range is Level. Level the range by placing a level horizontally on an oven rack. Check diagonally from front to back, then level the range by either adjusting the leveling legs or by placing shims under the corners of the range as needed. 13.After installation is complete,... - Page 11 lc. Convert the Pressure Regulator- Non-Self- 3. Convert Oven BurnerSpud Cleaning Standing Pilot Models Remove the cap from the pressure regulator. Remove the plunger from the cap. Turn the plunger with the enlarged end down for LP/ Propane use. Turn the plunger with the small end down for Natural gas use.