Connection To The Range - Kenmore 79041112200 Installation Instructions Manual

Electrical Connection to the Range
This appliance is manufactured with the neutral
terminal connected to the frame.
Three Conductor Wire Connection to Range
If local codes permit connection of the frame
grounding conductor to the neutral wire of the
copper power supply cord (see Fig. 3):
1. Remove the 3 screws at the lower end of the
rear wire cover, then bend the lower end of the
rear wire cover (access cover) upward to expose
range terminal connection block (see Fig. 2).
2.Using the nuts supplied in the literature package,
connect the neutral of copper power supply
cord to the center silver-colored terminal of the
terminal block, and connect the other wires to
the outer terminals. Match wires and terminals by
color (red wires connected to the right terminal,
black wires connected to the left terminal) (see
Fig. 3).
3.Lower the terminal cover and replace the 3
screws.
Silver colored Terminal
Red wire
Four Conductor Wire Connection to Range
Where local codes does NOT permit connection of
the frame grounding conductor to the neutral wire
of the copper power supply cord (see Fig. 4)
1. Remove the 3 screws at the lower end of the
rear wire cover, then raise the lower end of the
rear wire cover (access cover) upward to expose
range terminal connection block (see Fig. 2).
2. Remove the ground strap from the terminal block
and from the appliance frame.
3.Using the nuts supplied in the literature package,
connect the ground wire (green) of copper power
supply cord to the frame of the appliance with
the ground screw, using the hole in the frame
where the ground strap was removed (see Fig. 4).
4.Connect the neutral of the copper power supply
cord to the center silver-colored terminal of the
terminal block, and connect the other wires to
the outer terminals. Match wires and terminals by
color (red wires connected to the right terminal,
black wires connected to the left terminal).
5.Lower the terminal cover and replace the 3
screws.
Block Colored
Terminal
Wire
Terminal --
Block
Black
wire
A strainrelief
supplied by the user
must be installed at
this location
ro 240 V
receptacle
Figure 3
1-1/8" Dia,
Direct
Connection
Hole. Punch
out knockout
for 1-3/8" Dia,
Cord Kit Hole
Black
1-1/8"
Direct
Connection
Hole. Punch
out knockout
for 1-3/8" Dia.
Cord Kit Hole
A strainrelief
supplied by the user
must be installed at -To 240 V receptacle
this location
NOTE: Be sure to remove the supplied !_l
grounding strap
Figure 4
7