Brackets Installation - Kenmore 79041112200 Installation Instructions Manual

Anti-Tip Bracket Installation
To reduce the risk of tipping of the
range, the range must be secured to the floor by the
properly installed anti-tip bracket and screws packed
with the range. Failure to install the anti-tip bracket
will allow the range to tip over if excessive weight
is placed on an open door or if child climbs upon it.
Serious injury might result from spilled hot liquids or
from the range itself.
If range is ever moved to a different location, the
anti-tip bracket must also be moved and installed
with the range.
Instructions are provided for installation in wood
or cement floor. When fastening to floor, be sure
that screws do not penetrate electrical wiring or
plumbing.
A. Locate the Bracket Using the Template = Locate
the bracket position (right or left side) by placing
the template symmetrically to the center of the final
range position. Mark the location of the screw holes,
shown on template.
C. Level and position the rang_e_ - Slide range to its
final position. Insert the range leveling leg in the anti-
tip bracket. Visually verify if the anti-tip bracket is
engaged. Lower the range by adjusting the 4 leveling
legs alternatively until the range is level. Check if the
range is level by placing a spirit level on the oven
rack. Take 2 readings with the spirit level placed
diagonally; take a reading in one direction and then
in the other direction. Level the range if necessary by
adjusting the leveling legs.
Range side
Figure 14
Figure 12
B. Drill Pilot Holes and Fasten Bracket - Drill a 1/8"
pilot hole where screws are to be located. If bracket
is to be mounted to the wall, drill pilot hole at an
approximate 20 ° downward angle. If bracket is to
be mounted to masonry or ceramic floors, drill a
3/16" pilot hole 1-3/4" deep. The screws provided
may be used in wood or concrete material. Use a
5/16" nut-driver or fiat head screwdriver to secure
the bracket in place.
FASTEN BRACKET
(WALL OR FLOOR MOUNTING)
Leveling leg
i:iii:il
Floor Mount
Wall mount
i'
\ L/ / /'f
Anti-Tip Bracket
Figure 13
Figure 15
Figure 16
12