Table of Contents
Advertisement
Available languages
Available languages
30" DUAL FUEL SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
(Models with Sealed Top Burners)
Anti-Tip Brackets Installation
Instructions
EZ
Models Equipped with Leveling Device
CITE]
To reduce the risk of tipping of the range,
the range must be secured to the floor by properly
installed anti-tip bracket and screws packed with the
range. These parts are located in the oven. Failure to
install the anti-tip bracket will allow the range to tip over
if excessive weight is placed on an open door or if a child
climbs upon it. Serious injury might result from spilled hot
liquids or from the range itself.
Follow the instructions below to install the anti-tip
brackets.
If range is ever moved to a different location, the anti-
tip brackets must also be moved and installed with the
range.
Tools Required:
Adjustable Wrench
Ratchet
Drill & 1/8"(0,32 cm) bit
§/16" (0,8 cm) Nutdriver
Level
The anti-tip bracket attaches to the floor at the back of
the range to prevent range from tipping. When fastening
bracket to the floor, be sure that screws do not penetrate
electrical wiring or plumbing. The screws provided will
work in either wood or concrete.
].
Draw a center line (CL) on the floor where the range
should be installed. Also draw a line on the floor at
the range back position if there is no wall.
eo
Kitch
G
/
nrenen
cK EP ine °
| Cabinet
prick pil
gare wh
:
Toe
Door
ge
Ue
Plate
Cabinet
Oa
wn,
mo '
S
(26.7 em)
ANTI-TIP >.
BRACKET
CL = Center line)
Figure 17
14
. Unfold paper template and place it flat on the floor
with the right rear corner positioned exactly on the
intersection of the center and back lines you just drew
before. (Use the diagram below to locate brackets if
template is not available (Figure 17)).
. Mark on the floor the location of the 4 mounting
holes shown on the template. For easier installation,
3/16"(0,48 cm) diameter pilot holes 1/2"(1,27 cm)
deep can be drilled into the floor.
Remove template and place bracket on floor. Line up
holes in bracket with marks on floor and attach with
A screws provided. Bracket must be secured to solid
floor (Figure 20). If attaching to concrete floor, first
drill 3/16"(0,48 cm) dia. pilot holes using masonry drill
bit.
. Be sure the 4 leveling legs are at the highest position
they can be.
. Slide range into place making sure structure of the
range is trapped by the anti-tip bracket (Figure 18).
Lower the range by adjusting the 4 leveling legs until
the underside of the cooktop is sitting level on the
countertop. Refer to "Leveling the Range" section.
. After installation, verify that the anti-tip bracket is
engaged by grasping the top rear edge of the range
and carefully attempt to tilt it forward to make sure
range is properly anchored.
Anti-Tip Bracket]
/
| o— Wall
Range
Fioor
Floor Mount
Screws
Figure 18
Advertisement
Table of Contents
