Table of Contents
Advertisement
Caring for the Blender
Troubleshooting Guide
Problem . . .
Blender fails to start
or stops while it is
running and cannot
be restarted
Ingredients will not mix
properly
Maintenance
Inspect the blender and its various parts and replace as follows:
Daily
Unplug the blender and remove the container from the base, and then inspect the container and
cutter unit assembly for wear, nicks, and broken or loose blades. Replace if necessary. If the
cutter assembly blades are loose, discontinue use immediately and replace the cutter assembly.
Do not attempt to repair or tighten the cutter assembly. See "Replacement Parts" below.
Weekly
Unplug the blender, and then inspect the power cord insulation and power plug for cracks.
Refer to "Requesting Assistance or Service" for repair or replacement.
Yearly
Replace the container and cutter unit assembly at least once a year. See "Replacement Parts"
below.
Replacement Parts
Refer to "Requesting Assistance or Service" to order parts below.
Model
Part Description
1G901
1 container
1G908
1 container
1G909
1 container
1G910
1 container
1G918
1 container
1G919
1 container
ALL
Cutter unit assembly
840111501-EN
Solution . . .
• Check to see if unit is securely plugged into an electric outlet.
• Check to see if the fuse for the electric outlet has blown or if a
circuit breaker has tripped.
• Check to see if enough liquid has been added to the ingredients. Mixture should
be fluid and free-running at all times.
• Solid pieces are too large. Pieces should not exceed 1" (2.5 cm) cubes.
• Container is too full. Do not fill past highest graduation marking.
• Cutter unit blades are not sharp or are damaged. Inspect container and cutter
assembly daily. Replace container and cutter assembly at least every 12 months
or sooner if cutter assembly appears worn or damaged.
• Check to see if cutter unit assembly is installed properly.
• Select speed (on some models) to create a fluid blend.
261 Yadkin Road
Southern Pines, NC 28387
Part Number
6126-901
6126-908
6126-909
6126-910
98000
98100
99100
05/03
Advertisement
Table of Contents
