Related Manuals for Hamilton Beach 1G901
Summary of Contents for Hamilton Beach 1G901
- Page 1 Bar Blenders Models 1G901/1G908/1G909/1G910/1G918/1G919 Operation Manual www.commercial.hamiltonbeach.com 840111501-EN...
-
Page 2: Blender Safety
Failure to follow these instructions can result in broken bones or cuts. Model Number__________________________ Purchase Date__________________________ Dealer Name ___________________________ Dealer Address _________________________ Dealer Phone___________________________ You can also order replacement parts by calling your nearest Hamilton Beach Commercial Service Center or your local dealer. (www.commercial.hamiltonbeach.com) Cut Hazard... -
Page 3: Important Safety Instructions
• The use of accessory attachments not recom- mended by Hamilton Beach may cause injuries. • To reduce risk of personal injury, unplug cord from outlet when not in use, and before putting on or taking off parts or doing any other servicing of the blender. -
Page 4: Parts And Features
Become familiar with all parts and features before using your blender. Your blender is designed for blending and mixing beverages. Note: The Blender is not designed to crush ice. Ice cubes made in most icemakers may be added to liquid ingredients in the blender to make daiquiris or similar drinks. -
Page 5: Operation
Failure to follow these instructions can result in death, fire, or electrical shock. Controls Model 1G901: • The ON/OFF switch will turn the blender ON for continuous operation at approximately 18,000 RPM, or OFF. Models 1G908, 1G909, 1G910, 1G918, 1G919:... - Page 6 Pour in liquid, then add ice. Cover. Set speed at HIGH (except model 1G901) and process until desired consistency is reached. Chunks of frozen fruit can be added to milk or fruit juice to produce a sherbet or slush.
-
Page 7: Caring For The Blender
HiGH (except model 1G901) speed for a minimum of 2 minutes. 7. To dry, place empty container on base and run on HIGH (except model 1G901) speed for two sec- onds. 8. When ready to use, rinse with clean water. -
Page 8: Troubleshooting Guide
Inspect the blender and its various parts and replace as follows: Daily Unplug the blender and remove the container from the base, and then inspect the container and cutter unit assembly for wear, nicks, and broken or loose blades. Replace if necessary. If the cutter assembly blades are loose, discontinue use immediately and replace the cutter assembly.