Troubleshooting Guide; Maintenance; Replacement Parts - Hamilton Beach Tango Series Operation Manual

840080600env03 10/24/01 10:07 AM Page 9

Troubleshooting Guide

Problem . . .
Blender fails to start
or stops while it is
running and cannot
be restarted
Ingredients will not mix
properly
Model 91350 fails to
start when switch is
depressed.

Maintenance

Inspect the blender and its various parts and replace as follows:
Daily Unplug the blender and remove the container from the base, and then inspect the
container and cutter unit assembly for wear, nicks, and broken or loose blades.
Replace if necessary. If the blades are loose, discontinue use immediately and
replace the blades. Do not attempt to repair or tighten the cutter assembly. See
"Replacement Parts" below.
Weekly Unplug the blender, and then inspect the power cord insulation and power plug for
cracks. Refer to "Requesting Assistance or Service" for repair or replacement.
Yearly Replace the container and cutter assembly at least once a year. See "Replacement
Parts" below.

Replacement Parts

Refer to "Requesting Assistance or Service" to order parts below.
Model Part Description
91300/91350 1 container
91300/91350 Cutter assembly
Solution . . .
• Check to see if unit is securely plugged into an electric outlet.
• Check to see if the fuse for the electric outlet has blown or if a
circuit breaker has tripped.
• Check to see if enough liquid has been added to the ingredients.
Mixture should be fluid and free-running at all times.
• Solid pieces are too large. Pieces should not exceed 1" cubes.
• Container is too full. Do not fill past highest graduation marking.
• Cutter unit blades are not sharp or are damaged. Inspect
container and cutter assembly daily. Replace container and
cutter assembly at least every 12 months or sooner if cutter
assembly appears worn or damaged.
• Check to see if cutter assembly is installed properly.
• Select speed to create a fluid blend.
• Depress switch to the Off position, then release. Then turn blender
On according to the instructions.
Caring for the Blender
Part Number
6126-91300
99200
9