Troubleshooting Guide - Hamilton Beach HBH755-CN Operation Manual

Troubleshooting Guide

Problem . . . Solution . . .
Blender fails to start • Make sure that the Power Switch is in the ON (Reset) position and is illuminated red.
or stops while it is
• Check to see if unit is securely plugged into an electrical outlet of the proper voltage and
running and display is
blank.
• Check to see if the fuse for the electrical outlet has blown or if the Power Switch has tripped.
• This blender is equipped with motor overload protection. If the motor stops during operation
Blender fails to start • Make sure that the jar is seated properly on the blender base.
or stops while it is
• Blender will not operate unless jar is properly seated.
running; message
• Make sure Quiet Shield™ is down and in correct position.
appears in display.
Blender fails to start
• Thermal overload protection has been tripped. Attempt to run "cool down cycle." Follow
or stops while it is
running.
• This blender is equipped with motor overload protection. If the motor stops during operation
Unit does not respond
• Turn the power off and back on using the power switch to reset the controls.
to button commands
• Turn the power off and back on using the power switch. If the error message still appears, the
or error message
appears in display.
Ingredients will not • Check to see if enough liquid has been added to the ingredients. Mixture should be fluid and
mix properly.
• Solid pieces are too large.
• Container is too full. Do not fill past highest graduation marking.
• Cutter assembly blades are not sharp or are damaged. Inspect container and cutter assembly
• Check to see if cutter assembly is installed properly.
• Select speed to create a fluid blend.
frequency.
due to overheating, unplug and allow the blender to cool down for 15 minutes. Plug blender
back in after 15 minutes to resume normal operation.
instructions in display.
due to overheating, unplug and allow the blender to cool down for 15 minutes. Plug blender
back in after 15 minutes to resume normal operation.
unit will need to be serviced.
free-running at all times.
daily. Replace cutter assembly at least yearly or sooner if cutter assembly appears worn or
damaged.
7