Required Accessories And Tools; Supplied Accessories; Optional Accessories; Other Required Accessories From Specialist Outlets - Thermador T18 Series Installation Instructions Manual

Required accessories and tools
Supplied accessories
- Installation instructions
- Operating instructions
- Installation kit
Optional accessories
Basic Combination Side-by-Side Sealing kit
For permanent connection of two individual appliances, e. g.
Freezer next to Refrigerator.
Extreme Combination Side-by-Side Heating kit
If the gap between the appliances is less than 6" (160 mm).
Panel unification part (Metal strip)
For connection of two furniture doors. Can be used for
standard height furniture doors without further preliminary
work.
Other required accessories from
specialist outlets
Ice maker installation kit 1/4" OD copper line
For connecting appliances which require water,
e.g. for an ice maker.
Maximum outer diameter of the water pipe
(without fittings): 13/32" (10 mm).
Tools
- Cordless screwdriver T20
- Torx screwdriver T20
- Torx bit T20 + magnetic holder
- 5/1¢" (8 mm) hex nut driver
- Wood drills in different sizes
- Open end
wrench 1/2" (SW
13 mm)
- Multigrip pliers
- Adjustable wrench
- Cutter with adjustable blade
- Metal tape measure
- Square
- Spirit level length 2' (60 cm) and 4' (1,2 m)
- Marking-out level, length at least 4' (1.2 m) for individual
appliances or 7' (2.0 m) for Side-by-Side installation
Other
- Stepladder
- Dolly, hand truck
- Hammer drill for drilling holes in wall or floor
- Bits according suitable for material and in different sizes
- Wooden beam (cross section min. 3" x 4") as an
alternative tilt protection, length according to the width
of the installation cavity
- Wooden screws in different sizes
- Thin (max.
1/16"
(1.5 mm)), suitable material to protect
the floor from damage (e.g. lino)
- Suitable material for covering and protecting furniture
(e.g. protective sheets)
- Adhesive tape
Before using, check whether the removed adhesive
tape leaves adhesive residue on the work surfaces!
Otherwise do not use on high-quality work surfaces.
17