Remote Control - Sony RDR-HX900 Operating Instructions Manual

Timer recording is not complete or did not start
from the beginning.
, There was a power failure during recording. If
the power recovers when there is a timer
recording, the recorder resumes recording.
Should the power failure continue for more than
1 hour, reset the clock (page 88).
, Other timer setting overlapped the timer setting
(page 47).
, Disc space was not enough.
, The PDC/VPS function is working.
Contents previously recorded were erased.
, Data that has been recorded on a DVD with a PC
will be erased from the disc when the disc is
inserted.
, "Auto Title Erase" in the TOOLS menu (appears
when you press TOOLS while the Timer List
menu is turned on) is set to "On" (page 47).
, The title was updated and recorded over
(page 42).
The PDC/VPS function does not operate.
, Check that the clock and date are set correctly.
, Check that the PDC/VPS time you set is the
correct one (there might be a mistake in the TV
programme guide). If the broadcast you wanted
to record did not send the good PDC/VPS
information, the recorder will not start recording.
, If the reception is poor, the PDC/VPS signal
might be altered and the recorder might not start
recording.
, "PDC/VPS Scan Off" is selected (page 43).
Recording from the equipment with
a timer
Nothing was recorded even though you set the
Synchro-Rec setting correctly.
, You forgot to turn off the connected equipment.
Turn off the connected equipment and set the
recorder to Synchro-Rec standby mode
(page 51).
, The recorder was not set to the Synchro-
Recording standby mode. Press SYNCHRO
REC to have the recorder stand by for recording.
Make sure the SYNCHRO REC indicator lights
up on the front panel (page 51).
, The recorder is connected to the TV output jack
of the connected equipment.
102
Synchro-Recording does not complete.
, The timer setting for the connected equipment
overlapped the recorder's timer setting
(page 52).
, There was a power failure during the recording.
The recorder automatically starts recording
when the satellite receiver is turned on.
, The Synchro-Rec function was activated. Turn
off the satellite receiver and cancel the Synchro-
Rec function (page 51).
Display
The clock has stopped.
, Set the clock again (page 88).
, The clock stopped due to a power failure that
lasted for more than 1 hour. Reset the clock
(page 88).
The TIMER REC indicator is flashing.
, The disc does not have enough space.
, Insert a recordable disc inside the recorder.
The recording mode indication is incorrect.
, When the recording or dubbing is less than three
minutes, the recording mode indication may be
displayed incorrectly. The actual recording itself
is correctly made in the selected recording mode.
The clock does not appear in the front panel
display.
, "Dimmer" in Options Setup is set to "Power
Save" (page 97).

Remote control

The remote does not function.
, Batteries are weak.
, The remote is too far from the recorder.
, The remote's manufacturer code returned to the
default setting when you replaced the batteries.
Reset the code (page 20).
, Turn on the recorder.
, The remote is not pointed at the remote sensor on
the recorder.
, Different command modes are set for the
recorder and remote. Set the same command
mode (page 21).
, Set the TV/DVD switch to DVD (page 21).