Sony RDR-HX900 Operating Instructions Manual page 90

Progressive Mode
DVD software can be divided into two types: film
based software and video based software. Video
based software is derived from TV, such as
dramas and sit-coms, and displays images at 30
frames/60 fields (25 frames/50 fields) per second.
Film based software is derived from film and
displays images at 24 frames per second. Some
DVD software contains both Video and Film.
In order for these images to appear natural on your
screen when output in PROGRESSIVE mode (50
or 60 frames per second), the progressive video
signal needs to be converted to match the type of
DVD software that you are watching.
You can fine-tune the progressive 525p/625p
video signal that is output when you press
PROGRESSIVE ("PROGRESSIVE" lights up).
Note that you must connect to a progressive
format TV using the COMPONENT VIDEO OUT
jacks (page 15).
Auto
Automatically detects the
software type (Film-based or
Video-based) and selects the
appropriate conversion mode.
Normally select this position.
Video
Fixes the conversion mode to the
mode for Video-based software.
Screen Saver
The screen saver image appears when you do not
use the recorder for more than 10 minutes while an
on-screen display, such as the System Menu, is
displayed on your TV screen. The screen saver
image helps prevent your display device from
becoming damaged (ghosting).
On Turns on the screen saver
function.
Off Turns off the function.
Scart Setting
Sets the method of inputting/outputting signals
from the SCART jacks on the rear panel of the
recorder. Select an option for each of the items
below according to the combination of jacks and
methods that you are going to use.
90
Line1 Output
Selects a method of outputting video signals for
the LINE 1-TV jack.
RGB Outputs RGB signals.
Video
Outputs video signals.
S Video
Outputs S-video signals.
Notes
• If your TV does not accept S-video or RGB signals, no
picture appears on the TV screen even if you select "S
Video" or "RGB." See the instructions supplied with
your TV.
• You cannot select "RGB" when "Component Out"
above is set to "On."
• SMARTLINK is available only when "Video" is
selected.
Line3 Input
Selects a method of inputting video signals for the
LINE 3/DECODER jack. The picture will not be
clear if this setting does not match the type of
video input signal.
Video/RGB
Inputs video signals or RGB
signals.
Decoder
Select this when connecting to a
PAY-TV/Canal Plus decoder.
S Video
Inputs S-video signals.
Line3 Output
Selects a method of outputting video signals for
the LINE 3/DECODER jack.
Video Outputs video signals.
S Video
Outputs S-video signals.
Line4 Input
Selects a method of inputting video signals for the
LINE 4 IN jack on the rear panel of the recorder.
Video
Inputs video signals.
S Video Inputs S-video signals.