Face Mounting Brackets -- Arched, Metropolitan, Artisan Vict. Lace Faces; Metropolitan, Artisan Vict. Lace Faces; Mounting The Bedford Face - Travis Industries 31 DVI Owner's Manual

12
Installation (for qualified installers only)

Face Mounting Brackets -- Arched, Metropolitan, Artisan Vict. Lace Faces

Some Arched, Artisan, Metropolitan, and Victorian Lace Faces include old brackets that will not mount to
the heater (see illustration below). For these faces, make sure to use the new mounting brackets (either
included with the heater or available through your dealer - SKU 250-00519).
WARNING: When attaching the Victorian Lace Face, do not over-tighten the screws. Over-tightening
the screws may damage the face – simply tighten the screws until they contact the face.
Old Victorian
Old Arched,
Metropolitan, or
Artisan Bracket Bracket
NOTE: The face attaches to the brackets with the screws included with the face – see the instructions
included with the face.

Mounting the Bedford Face

Some Bedford Faces include old brackets that will
not mount to the heater. For these faces, make
sure to use the new DVS Insert EF II Face
Upgrade Kit (either included with the face or
available through your dealer - SKU 250-00029).
The kit lowers the face and surround panels 1-1/4".
This means you must install this with a raised
fireplace or raise the insert 1-1/4" above the hearth.
To do this you may extend the leveling bolts or
place bricks or other non-combustible under the
insert.
© Travis Industries
New
Lace
Bracket
Install the face mounting brackets to
the heater with the included nuts.
4100322
NOTE: The brackets
install with this pair of
closely spaced
flanges at the top.
1-1/4"
100-01235_000