Rear-Facing Lap-Shoulder Belt Installation - Britax Marathon User Manual

Installation: Rear-Facing
Rear-Facing
Lap-Shoulder Belt Installation
• Figure A illustrates a typical rear-facing
lap-shoulder belt installation.
• When not in use, always store the LATCH
connectors in storage pouches sewn in
cover above rear-facing lock-offs.
1 Place the child restraint rear-facing and
in full recline position on the vehicle seat .
2 Open rear-facing lock-off farthest from
where the vehicle belt will be buckled .
3 Pull the vehicle belt out, then pass it
through the first rear-facing belt slot (Fig.
B) .
• The vehicle belt can be routed over or
under the cover.
4 Route vehicle belt behind and under
the buckle strap, then through the
second rear-facing belt slot .
5 Verify that the vehicle belt is not
twisted, then buckle (Fig. C) .
6 Push the restraint firmly into the seat
while removing slack from the lap portion
of the vehicle belt, then the shoulder
portion (Fig. D) .
12
A
B
C