Resetting - Mercedes-Benz M-Class Operator's Manual

Side windows
96
Using the SmartKey
The SmartKey must be in the vicinity of the
vehicle, on vehicles without KEYLESS-GO the
SmartKey must be near the door handle.
Vehicles without KEYLESS-GO: point the
X
tip of the SmartKey at the door handle on
the driver's door.
Press and hold the & button until the
X
side windows and the sliding sunroof or the
panorama roof with power tilt/sliding
panel are fully closed.
Make sure that all the side windows and the
X
sliding sunroof or panorama roof with
power tilt/sliding panel are closed.
On vehicles with a panorama roof with power
tilt/sliding panel:
Press and hold the & button again until
X
the roller sunblinds of the panorama roof
with power tilt/sliding panel close.
To interrupt convenience closing:
X
release the & button.
Using KEYLESS-GO
The KEYLESS-GO key must be outside the
vehicle. All the doors must be closed.
Touch recessed sensor surface : on the
X
door handle until the side windows and the
sliding sunroof or the panorama roof with
power tilt/sliding panel are fully closed.
i
Make sure you only touch recessed
sensor surface :.
Make sure that all the side windows and the
X
sliding sunroof or panorama roof with
power tilt/sliding panel are closed.
On vehicles with a panorama roof with power
tilt/sliding panel:
Touch recessed sensor surface : on the
X
door handle again until the roller sunblinds
of the panorama roof with power tilt/
sliding panel close.
To interrupt convenience closing:
X
release recessed sensor surface : on the
door handle.
Resetting the side windows
If a side window can no longer be closed fully,
you must reset it.
Close all the doors.
X
Turn the SmartKey to position 1 or 2 in the
X
ignition lock.
Pull the corresponding switch on the door
X
control panel until the side window is
completely closed. (
Hold the switch for an additional second.
X
If the side window opens again slightly:
Immediately pull the corresponding switch
X
on the door control panel until the side
window is completely closed (
Hold the switch for an additional second.
X
If the corresponding side window remains
X
closed after the button has been released,
the side window has been reset correctly.
If this is not the case, repeat the steps
above again.
page 94)
Y
page 94).
Y