Table of Contents
Advertisement
Please install and adjust the machine according to the requirement of the manual.
It is very important to your security and correct operating the machine.
Install the inner cover components
1.Open the top lid of the washing machine.
2.Put the inner cover component on the outer tub cover, aiming
the inner cover shaft to the installation hole of the corresponding
outer tub cover shaft groove.
3.Firstly insert the inner cover shaft of I side into the correspon
-ding outer tub cover shaft groove, then push the another inner
cover shaft into the corresponding outer tub cover shaft groove.
Please install to designated position to guarantee there are no
dropping or abnormal sound in opening and closing of the inner
cover, and the operation shall be smooth. Do not dismount the
inner cover component after washing.
Install the bottom plate
After opening the package, please lean
the washing machine gently down on
soft items (like towel cloth, blanket, etc.).
Install the bottom plate to the bottom
of the machine with eight screws by a
c r o s s s c r e w d r i v e r , t h e n l i f t t h e
machine up gently. See to the figure:
Adjust the Installation position
The largest allowed slope of the shank base of the machine is 2 . The slanting or rough ground will result in
unstable running or stoppage of the machine. Please adjust it with following methods:
Confirm it's horizontal
Hang the plumb to confirm it's
Adjust the adjustable foot
(1) To twist the adjustable foot at the right front of
the cabinet (front the sight of front), please first
lift up the side of the foot slightly, loosen the
adjustable nut, and twist the foot.
(2) Fasten the nut after adjustment.
4
horizontal
Bottom plate
Loosen
High
Low
Outer tub cover
shaft groove
Inner cover shaft
Outer tub cover
Inner cover
Back
Front
Soft items
Screw
adjustable nut
Fasten
adjustable foot
Advertisement
Table of Contents
