Related Manuals for Haier XQS70-98
Summary of Contents for Haier XQS70-98
- Page 1 Double-drive Automatic Washing Machine This manual is for XQS70-98 Please read this manual carefully before using. Retain it for future reference.
-
Page 2: Table Of Contents
Contents Names of the parts... Safety precautions... Installation and adjustment... Install the water inlet hose..6 Preparation before washing... Put in the laundries... Use of the detergent... Use the operation buttons... Close the top lid... Finish washing... Disposal after washing... Trouble shooting answer to question... -
Page 3: Names Of The Parts
Names of the parts Top lid components Inner cover components Detergent box Control panel seat Outer tub cover Balance ring Attachment block 3 pieces Inner tub Lint filter Pulsator Control panel coating Cabinet Liquid blenching filler Adjustable leg The figure in this manual being sketch map and with the improvement of our products, the machine you buy is like to be different from the figure indicated in the manual .Please understand. -
Page 4: Safety Precautions
Safety precautions Please plug the power plug on special receptacle. Be sure to use three-pins power receptacle. Ensure that the earthing prong of the power receptacle is earthed reliably. Use leakage protector if possible. Do not bend ,extend,twist,bind by force.Do not press or nip it with weight. Keep the pin of the power plug clean,if the power plug is polluted with dust,please wipe with dry cloth carefully. - Page 5 Do not stretch hands into the working machine. It is dangerous even if the rotation is slow. Take special care of the chil d ren. Do not put any hot or heavy items (such as the kettle with hot water) on the washing machine The appliance is not instruct for use of young children of infirm persons without supervision.Young children should be...
-
Page 6: Installation And Adjustment
Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine. Install the inner cover components 1.Open the top lid of the washing machine. 2.Put the inner cover component on the outer tub cover, aiming the inner cover shaft to the installation hole of the corresponding outer tub cover shaft groove. -
Page 7: Usage Of The Drain Hose
How to change the direction of the drain hose 1.Lean the machine down gently with the front surface facing the ground. Loosen the eight screws by a cross screwdriver. Back Front 2.Pull out the drain hose from the groove at the left side. Use groove at this side after direction changing... -
Page 8: Install The Water Inlet Hose
Install the water inlet hose Confirm the water faucet water faucet, suitable It is required that the front end shall be longer than 10mm. The exit end face of the faucet shall be flat and smooth. If not please file it to avoid leakage. Connection between the water inlet hose jointerand the water faucet 1.Press the lower end of the lock lever and push down the slider. -
Page 9: Connection Between The Water Inlet Hose And The Washer
Connection between the water inlet hose and the washer 1.Do not take off the water absorption cushion. Please check if the cushion is dropped or damaged before each usage. If it happens please contact our after-sale department immediately. 2 Put the nut of the water inlet hose on the valve jointer. -
Page 10: Preparation Before Washing
1 Preparation before washing Pay attention to following before washing Check C l e a r Pay attention to followings before washing the laundries the laundries pocket. Take has special out the coins, requirement sand, hairpins on washing etc. a. Check if the laundries are applicable for washing with machine. b. -
Page 11: Put In The Laundries
2 Put in the laundries 3 Usage of the detergent Washing powder inlet entrance Softener inlet entrance How to use the whitener Fill water to decided level .Dilute the whitener with container. Pour it slowly into the washing tub. Avoid using whitener on laundries with colour or pattern as they are prone to lose colour. -
Page 12: Use The Operation Buttons
4 Use the operation buttons Description of the function of the buttons Mode and meaning of the VFD indicator Flashing indicating the running program On indicating the program about to run or the selection mode SOAK button WASH button Push the SOAK button Push the WASH button to set the soak procedure. - Page 13 Child lock function This function is used to protect the children and prevent them from changing the washing procedure. Push and hold the WATER LEVEL button and SPIN button, then push down the POWER ON/OFF button. The digitron displays CL . You can continue setting desired washing procedures.
- Page 14 Steps of using the operation buttons and description of the steps Minutes Minutes Push the "POWER ON/OFF " button to switch on the power. Push the "PROGRAM" button After switching on the power, the machine will set normal program automatically. To select other automatic program, push the "program"...
- Page 15 After switching on the power, the washing machine will set to common program including"wash, rinse, spin "automatically. To select other procedures, push the " SOAK"," WASH", " RINSE" or "SPIN" button to select the time of soak,wash and spin, and the times of rinse. After switching on the power, if you push one of the button among "WASH", "RINSE"and"SPIN", the digitron of the former procedures will turn off automatically.
-
Page 16: Close The Top Lid
Push the "START/PAUSE" button 5 Close the lid As the top lid opened ,the Washer will automatically give an alarm and stop running , exclusively during supplying water and rinsing. 6 Finish washing After finishing wash it'll switch off the power automatically. -
Page 17: Disposal After Washing
7.Disposal after washing After using, please clean the lint and foreign materials of the lint filter etc. in time. Otherwise it may influence your using the machine. Please first pull off the power plug from the receptacle before cleaning. Clean the detergent box and set it on the control panel seat. -
Page 18: Trouble Shooting Answer To Question
Trouble-shooting Answer to question (If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after-sale service department of our company. -
Page 19: Packing List Specification
Packing list User's manual Inner cover components Component of the water inlet hose The end connecting to the washing machine Jointer connecting the The end connecting to the water inlet hose jointer Bottom cover Topping screws Full automatic washing machine Specification Water level/Water quantity (about)