Lincoln 2013 MKZ Owner's Manual page 202

Graphic display
(bars between
vehicles)
1 bar
2 bars
3 bars
4 bars
Each time the vehicle is restarted, the
last chosen gap for the current driver
will be automatically selected.
Disengaging the System
Press the brake pedal or press CNCL.
The last set speed will be displayed
in grey but will not be erased.
Overriding the System
WARNING
Whenever the driver is overriding
the system by pressing the
accelerator pedal, the system will not
automatically apply the brakes to
maintain separation from any vehicle
ahead.
The set speed and gap distance can
be overridden by pressing the
accelerator pedal.
When you override the
system, the green indicator
E144529
light is illuminated, and the
follow vehicle is not shown in the
information display.
Cruise Control
Following
distance
mph (100 km/h)
1 second
1.5 seconds
1.9 seconds
2.3 seconds 66 yards (64 m)
199
Following
distance at 60
29 yards (28 m)
44 yards (42 m)
56 yards (53 m)
The system will resume operation
when you release the accelerator
pedal. The vehicle speed will decrease
to the set speed, or a lower speed if
following a slower vehicle.
Changing the Set Speed
• Accelerate or brake to the desired
speed, then press and release
SET+.
• Press and hold SET+ or SET- until
the desired set speed is shown on
the information display. The
vehicle speed will gradually
change to the selected speed.
• Press and release SET+ or SET-.
The set speed will change in
approximately 1 mph (2 km/h)
increments.
The system may apply the brakes to
slow the vehicle to the new set speed.
The set speed will display
continuously in the information
display while the system is active.
Dynamic behavior
Sporty
Normal
Normal
Comfort