Chapter 2. Getting Ready To Sew; Choosing And Changing Accessories - Singer 5122 User Manual

Chapter 2. Getting Ready to Sew
choosing and changing accessories
CHANGING THE NEEDLE
" Raise needle to its highest point by turning
the hand wheel toward you. Loosen needle
clamp screw A and remove the needle.
A
" Insert new needle up into clamp B as far as it
I
A
will go, with the flat side of the needle to the
back.
" Tighten needle clamp screw.
CHANGING PRESSER FEET
The general purpose foot is on your machine when delivered. To change to another foot, raise
needle to highest position by turning the hand wheel toward you. Raise presser foot.
To Remove and Replace Foot
AZ
U1
1. Insert the edge of a coin in the slot of the
2. When screw is fully loosened, foot will drop.
presser foot screw A. To loosen, turn screw
Remove presser foot by sliding it toward you.
away from you.
3. Centre the new presser foot shank B under
4. Tighten presser foot screw securely with a
the presser foot screw. Lift shank all the way
coin.
up.
4