Sewing A Seam; Keeping The Seam Straight - Singer 5122 User Manual

sewing a seam
it
*
~~Needle
Position.m
I}
* Stitch Width:
l
* Stitch Length: To suit fabric
* General Purpose Needle Plate
*
General Purpose Foot
1 1.Raise presser foot. Pull thread back under
presser foot leaving at least I10cm (4 inches)
of thread.
2. Position needle approximately 1.3cm (1/2
inch) from fabric edge. Then lower presser
foot and backstitch almost to the edge of the
7
fabric for reinforcement by stitching
in
reverse direction. For additional information
on reverse stitching refer to page 17. Stitch
forward to end of seam and stop machine
before the end of stitching line. (Do not sew
3
t
beyond edge of fabric).
CAUTION: Do not pull the fabric while you are
stitching as this may deflect the needle caus-
ing it to break.
3. Raise needle by turning hand wheel toward
you. Press reverse stitch push button, and
back stitch 1.3cm (1 /2 inch) to reinforce
end of stitching.
4. Raise needle-by turning hand wheel toward
you. Raise foot and remove fabric by drawing
-&
it to the back and to the left. Cut threads on
thread cutter at rear of presser bar.
KEEPING THE SEAM STRAIGHT
For extra help in keeping the seam straight, you
may wish to use the seam guide. Because it
allows you to guide stitches evenly between
1.3cm (1/2 inch) and 3.2cm (1-1/4 inches)
from the fabric edge, it is particularly useful for
very narrow or very wide seams.
CAUTION: Because of the up and down move-
Lj M ment of the needle, you must work carefully and
watch the sewing area when operating the
machine.
18