Singer 5122 User Manual page 7

REMOVING AND REPLACING NEEDLE
t
PLATE
* Raise needle to highest position and raise
a
a
B
presser foot.
1 Remove screws A and B using a large
screwdriver.
2. Remove the needle plate by simply guiding it
toward you.
To replace deedle plate, guide needle plate
into position under the presser foot. Replace
-
screws A and B using a large screwdriver
and tighten securely.
2O
ATTACHING SNAP-IN FEED COVER
E
" Raise needle to highest position by turning
handwheel toward you.
. Raise presser foot.
C
" Slide snap-in feed cover away from you over
needle plate until points C and D are posi- "(
tioned directly over holes in needle plate as
illustrated. Snap in point C. Then push point
D toward point C until it snaps into place.
Push down on point E until it also snaps into
place.
" To remove, lift up edges of feed cover.
ATTACHING THE SEAM GUIDE
Place screw in either hole to the right of the
needle plate; line up straight edge of guide with
the needle plate guideline for desired seam
width, and tighten screw. / / ,-
5