Winding The Bobbin - Singer 8007; 8019; 8002 Instruction Book

Winding a bobbin
Winding a bobbin is quick and easy when you follow the directions below. Always wind
the bobbin before threading the machine and needle.
" Push in indent (1) on hand wheel disc. This will stop The needle from moving,
" Place spool of thread on spool pin
" Slide spool cap (2) firmly over rim of spool to prevent thread tangling.
" Lead thread from spool and snap into thread guide post (3).
* Wind thread clockwise around front of bobbin winder tension disc (4).
* Pass thread end, from inside, through small hole in rim of bobbin.
" Place bobbin on spindle and push it to the right
* Holding thread end, step on speed controller to run machine until desired amount of thread
is wound. (Winding stops automatically onpe bobbin is full.)
" Cut thread; push bobbin to the left and remove it from spindle.
" Trim thread end from top of bobbin.
" Return hand wheel disc to sewing position by pressing on side opposite indent.
3
/
4
0
RItI
11