Ending A Seam
I1.
Leave presser foot in down position
Depress and hold reverse-stitch push but-
ton and run the machine at slow speed
2
While holding reverse-stitch push button,
back-stitch about 1.3cm (1/2") in from
edge of fabric to reinforce end of seam..
2. Then release push button. With the take-
up lever at its highest point, raise the
presser foot and remove the fabric by
drawing it back and to the left.
1. Cut thread ends on thread cutter at rear of
presser bar.
Guiding and Supporting Fabric
4.
Most fabrics need only to be guided in
i
front of the presser loot.
CAUTION:
Do not pull the fabric as you
apply gentle or firm tension while stitch-4
ing, as this may deflect the needle. causing
it to break.
S, Some fabrics, such as filmy sheers, knits,
etc., require support in front and back of
the presser toot while being stitched.
20