Table of Contents
Advertisement
Changing Pressor Feet
Most presser feet furnished with your machine
snap on and off a common shank
5
r
* Raise needle and take-up lever to highest
position by turning hand wheel toward you
.Raise presser
toot
Y
$
<
To remove the complete presser toot (with
shank), of snap-on presser feet and one-
•"
piece presser foot for button sewing, loosen
1 Press toe of presser toot upward asfar as it
the presser foot screw and remove shank and
foot together
will go Then snap down to remove
i$
2 Center the new presser
toot
under the
>
shank J.
Lower the presser toot titter K so that the
3 Press presser foot screw down firmly until
shank fits over the presser toot pin
foot snaps into place
Removing and Replacing
Attaching Snap-In
Needle Plate
Feed Cover
* Raise presser foot
. Raise needle to highest position by turning
hand wheel toward you
.Turn hand wheel toward you untit the needle
is in its highest position
. Raise presser foot, open slide plate and in-
sert zig-zag needle plate
* Open the slide plate, Lift
needle plate up and to
the right until it snaps free
- Slide snap-in feed cover away from you over
needle plate until points (1) and (2) are positioned
" Insert new needle plate by placing it under the
directly over holes in needle plate as i.lustrated
clamping pin (1) push it gently to the left and
Snap in point (1) Then push (2) in toward point
press down unlit it snaps into place
(1) until it snaps into place Close slide plate
" Close slide plate
*
To remove, open slide plate then simply lift
up front edge of feed cover, and remove
Close slide plate
I
I
vioil
7
Hide quick links:
Advertisement
Table of Contents
