Table of Contents
Advertisement
DMX Linking
DMX Modes
Master/Slave
Connectivity
Legend™ 412 Series User Manual Rev. 04
You can link the Legend™ 412 Series to a DMX controller using a standard 5-pin DMX
serial connection. If using other DMX compatible products with the Legend™ 412 Series,
you can control each individually with a single DMX controller.
The Legend™ 412 Series uses the standard 5-pin DMX data connection for its ADVANCED
and BASIC DMX personalities.
Refer to the
Introduction
Refer to the
Operation
chapter to learn how to configure the Legend™ 412 Series to work in
these modes.
The
DMX Values
section will provide you with detailed information regarding the DMX
modes.
The Master/Slave mode allows a Legend™ 412 or a Legend™ 412 VW (the "master unit")
to control one or more Legend™ 412's or Legend™ 412 VW's (the "slave units") without a
DMX controller. The product becomes the master unit when set in master mode via the
control panel. You must configure the slave units to operate in one of the two (2) slave
modes from their respective control panels. During the Master/Slave operation, the slave
units will operate in unison with the master unit or run offset depending on the slave mode
chosen.
Do not connect a Legend™ 412 together with a Legend™ 412 VW in Master/Slave
mode.
If you are not familiar with or need more information about DMX standards, master/slave
connectivity, or the DMX cables needed to link this product to a DMX controller, download
the document DMX Primer from the CHAUVET® website:
DO NOT connect a DMX controller to the products operating in Master/Slave mode.
The DMX controller signals may interfere with the signals from the master product.
The
Operation
chapter of this manual provides detailed instructions on how to
configure the Master and Slave products.
chapter for a brief description of these modes.
www.chauvetpro.com
Setup
-9-
Hide quick links:
Advertisement
Table of Contents
