Installing The Modem Using The Ethernet Port - Ubee DDW2600 User Manual

4
Try positioning the computer closer to the wireless cable modem. The
wireless signal may be weaker after it has passed through metal, concrete,
brick, walls, or floors. Make sure that the wireless cable modem and wireless
adapters are positioned so that the signal will travel straight through a wall or
ceiling for better reception. For example, a wall that is 1 foot thick, at a 45-
degree angle appears to be almost 2 feet thick.
Make sure PC's wireless client is connecting to right WLCM. Check the
SSID of the WLCM and wireless client.
If WEP (Wired Equivalent Privacy) is set, verify that the WEP key set in the
modem matches the WEP key set in the wireless client
4. Installing the Modem Using the
Ethernet Port
This chapter explains the process for installing your wireless cable modem
using the Ethernet port. Using the Ethernet port allows to you connect multiple
computers to a wireless cable modem through the use of additional equipment
which is not included. Please contact your cable service provider for more
information on using multiple computers.
You can use the wireless cable modem
A PC running Windows 95 (or later) operating system or a Macintosh
computer running system 7.6 (or later) operating system
An active Ethernet port on your PC
Before you begin, verify that your Network Interface Card (NIC) has been installed
and configured for use with your wireless cable modem. The wireless cable
modem requires TCP/IP to be installed. Contact your cable service provider for
assistance with installing and configuring TCP/IP. After installed the hardware,
your computer can connect the wireless cable modem directly by using Network
Interface Card. Unlike USB installation, there is no needed for software installation
for the Ethernet connection.
Installing the Hardware
DDW2600/DDC2700

Installing the Modem Using the Ethernet Port

'
s Ethernet port if you have: