Table of Contents
Advertisement
Vax V-083(Q) User Guide.qxd
Rotate the brush while pulling it in and out of the chamber.
Insert the steam nozzle back into the chamber and turn it
clockwise to lock back into position.
N.B Vax recommends cleaning the chamber after
every 12-15 uses to ensure optimum performance.
Unblocking the Steam Outlet
If steam flow appears reduced, the steam nozzle may be
blocked.
Insert the nozzle pin into the centre of the steam nozzle.
This will clear any blockage that may have formed.
Cleaning the Cloths
Both the floor and utility tool cloths can be machine
washed (60ºC max). For heavy soiling, soak the cloths in
warm water and detergent or a mild stain remover. Allow
to dry completely before storing.
25/1/07
11:11
Page 7
7. Troubleshooting
!
PROBLEM: Steam cleaner has no power
Cause:
Solution: Insert the plug into an electrical outlet and
Cause:
Solution: Check the socket by unplugging the steam
Cause:
Solution: Have the cable replaced by a Vax Service Agent.
PROBLEM: No steam is emitted when the steam
Cause:
Solution: Top up with water.
Cause:
Solution: Refer to section 6.
Cause:
Solution: Press down the steam switch fully.
Cause:
Solution: Shake the steam cleaner gently.
PROBLEM: Only a very small amount of steam flows
Cause:
Solution: Turn the steam controller until sufficient
Vax Careline
WARNING: To reduce the risk of personal injury,
unplug the steam cleaner before servicing.
Steam cleaner is not properly plugged into an
electrical outlet or is not switched on.
switch the steam cleaner on.
The socket is faulty.
cleaner and plugging in a different appliance.
The power cable is damaged.
cleaner is on.
The water tank is empty.
The steam nozzle is blocked.
Despite the green light, the steam switch is
not activated properly.
The weighted tubing inside the tank is not in
the correct (immersed) position.
out of the steam cleaner.
The steam regulator is set to minimum.
steam is emitted.
maintenance / troubleshooting
0870 606 1248
7
Advertisement
Table of Contents
