Page 1
Duet Master 2 in 1 stick steam and handheld cleaner Get Cleaning... What ’ s your Vax ’ s model number? What ’ s your serial number? (Located on the base of the machine) Note these down in case you need them in future. Please keep instructions for further use.
If the supply cord is damaged call the Vax Careline on AU 1300 361 505 / NZ 0800 800 900. return the steam mop to a Vax authorised Service Agent.
Page 5
WARNING: Never leave the steam mop in one spot on any surface for an extended period of time as this may damage the floor surface. Always return the mop back to the resting tray when not in use or when not continuously moving across the floor. vax.com.au...
Replace the clean water tank, pressing the quick release button. 400ml of clean water. Replace the clicking in place making sure the water cap. hard water lter is in place. Vax Service line: AU: 1300 361 505 NZ: 0800 800 900...
Page 7
IMPORTANT: Carefully remove the cleaning pad from the oor head as the pad and oor head may be hot. Velcro micro bre cleaning pad Hold corner of pad down with foot and peel unit away vax.com.au...
Page 8
(within continuously. 1 minute). IMPORTANT: For 1 x 400ml water tank = 12 minutes steaming time (approx). Vax Service line: AU: 1300 361 505 NZ: 0800 800 900...
To prevent overly wetting paying particular attention carpet, do not hold down to high tra c areas. continuously. vax.com.au...
Page 10
When using handheld steam mop To produced steam push the attach the accessory connector button on top of the main body 1 and then attach the desired in short bursts. accessory 2. Vax Service line: AU: 1300 361 505 NZ: 0800 800 900...
Maintenance (Keep your Vax as good as new) Empty the water tank IMPORTANT: Allow the unit to fully cool down before performing any maintenance or troubleshooting checks. Remove the clean water tank by Remove the water cap. Empty any excess water over the pressing the quick release button.
Maintenance (Keep your Vax as good as new) Replacing the hard water lter IMPORTANT: The condition of the lter a ects the performance of your machine. Check and change lter (depending on level of use). Do not operate unit without hard water lter in place.
Page 13
The electrical outlet may not be working properly, check the fuse or breaker, or consult an electrician. The power cord may be damaged, if it is it must be replaced by the manufacturer or Vax authorised agent in order to avoid invalidating the warranty.
8.30am to 5.00pm If you have queries or concerns about using your Vax, call the Vax Careline. Calls are charged at the standard local rate. Please make a note of the serial number and model number of the vacuum cleaner before calling.