Operation - Vax Upright Steam Cleaner V-083 Instruction Manual

Vax V-083(Q) User Guide.qxd
Secure the floor head inside the carpet glide base and
connect the cloth to the attachment by using the towel
grips (Fig.4/3).
Cloth
Fig.4/3
Use slow forward and backward cleaning strokes over the
desired area.
For carpets and rugs – leave the steam regulator control
set to "maximum"
For flat pile – Unscrew and remove the corner gliders
Hard Floor Cleaning
Reduce the steam flow to a lower setting by turning the
steam control regulator. Use both forward and backward
strokes across the floor area.
N.B When the cloth becomes very wet, rinse out the
moisture, use the reverse side or replace with a clean, dry
cloth. If the towel becomes too dirty, rinse out the dirt,
use the reverse side or replace with a clean, dry cloth.
Stubborn Stains
For removing stubborn stains or embedded grime on hard
surfaces, fold and attach the cloth leaving the brushes
underneath the floor head visible. (Fig4/4).
Fig.4/4
25/1/07 11:11 Page 5
Move the brush sliders so that the brushes appear
underneath the floor head. Move the brushes backwards
and forwards over the selected area.
N.B Do not use the brushes for routine carpet and hard
floor cleaning as unnecessary scrubbing may cause
damage. The brushes should only be used for
removing stubborn stains and grime.
Carpet Pile Rejuvenation
To rejuvenate flattened carpet piles, remove the cloth and
connect the carpet glide base to the floor head with the
steam comb section in place.
Fig.4/5
!
cleaner to cool down before changing the accessories.
Never open the water tank cap whilst the steam
switch is on.
Vax Careline
(Model: V-083Q only)
IMPORTANT: The housing and accessories
become hot during operation. Allow the steam
0870 606 1248
5

operation