Advertisement
Installation
Instructions
I_IGARAGE INSTALLATION
(IF ALLOWED
BY LOCAL CODES)
• Dryers installed in garages must be elevated 18 inches
(46cm) above the floor.
IT3-1DRYEREXHAUST TO RIGHT, LEFT
OR BOTTOM CABINET
WARNING - BEFORE P ERFORMING
THIS EXHAUST INSTALLATION,
BE SURE
TO DISCONNECT THE DRYER FROM ITS
ELECTRICAL SUPPLY. PROTECT YOUR
HANDS AND ARMS FROM SHARP
EDGES WHEN WORKING
INSIDE THE
CABINET. BE SURE TO WEAR GLOVES
REMOVE
SCREW
AN DSAVE.
REMOVE,_)
DESIRED
KNOCKOUT
lONE ONLY).
Detach and remove the bottom, right or left side knockout
as desired. Remove the screw inside the drger exhaust duct
and save. Pull the duct out of the drger.
Note: Onlg 4" round rigid metal ducting allowed inside
drger.
FIXING HOLE
B
A
9"
Cut the duct as shown and keep portion A.
TAB LOCATION
BEND TAB
UP45 o
Through the rear opening, locate the tab in the middle of
the appliance base. Lift the tab to about/450 using a flat
blade screwdriver.
ADDING NEW DUCT
FIXING
HOLE
PORTION
"A"
LEFT S IDE
EXHAUST
Reconnect the cut portion (A)of the duct to the blower
housing. Make sure that the shortened duct is aligned with
the tab in the base. Usethe screw saved previouslg to secure
the duct in place through the tab on the appliance base.
ADDING ELBOW AND DUCT FOR
EXHAUST TO LEFT SIDE OF CABINET
• Preassemble 4" elbow with 4" duct. Wrap duct tape
around joint.
• Insert duct assembly, elbow first, through the side
opening and connect the elbow to the dryer internal
duct.
CAUTION:
Be sure not to pull or damage
theelectrical
wiresinside thedryerwhen inserting the
duct.
BEADDEDTO _!I/
-:Sj _ j
_Mf
EXHAUSTCAN
__
__
LEFT O RR]GHT S IDE
_
• Apply duct tape as shown on the joint between the
dryer internal duct and the elbow.
DUCT
,TAPE
CAUTION:
Internal duct joints must be
secured with tape, otherwise
they may separate and cause
a safetg hazard.
7
Advertisement
