Of Top Cabinet; Assemble And Install Adaptor; Mount The Oven - GE JVM1600 Series Installation Instructions Manual

Installation Instructions
I-_ USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws, a
hole large, enom,h,_ for the power cord to fit through,
and a cutout large enouoh., for the exhaust adaptor.
/il
%
• Read tile instructions on tile TOP CABINET
TEMPLATE.
" Tape it tmderneath the top cabinet.
• Drill the holes, following the instructions on the
TOP CABINET TEMPI,ATE.
CAUTION: Wear safety goggles when drilling holes
in tile cabinet bottom.
ASSEMBLE AND
INSTALL ADAPTOR
Damper
Adaptor
_ Place tile oven in its upright position, with tile top
of the trait lacing up.
NOTE: Make sure the blower fan blades are visible
and are pointing up,
_Insert the tabs on each side of the damper into the
holes at the inside rear of the adaptor.
_ Attach the exhaust adaptor to the blower plate with
the two bronze metal screws provided.
Make sure that the damper pivots easily before
mounting oven.
You will need to make a(!justments to assure proper
alignment with your house exhaust duct atter the
oven is installed,
I-_ MOUNT THE OVEN
FOIl EASIER INSTAI,IATION AND PERSONAl,
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of the cord.
NOTE; We recommend using filler blocks if the
cabinet fl'ont hangs below tile cabinet bottom shelf.
IMPORTANT: If filler blocks are not
used, case damage may occur from over
tightening screws.
NOTE: When mounting tile
()veil, thread power
cord
through hole in bottom
of top cabinet. Keep it tight
throughout Steps 1-3.
Do not pinch cord or lift
oxen b_, I)ulling, cord.
_I,ifl tilt it
oven,
fi)rward and hook
slots at back bottom
edge onto two lower
tabs of mounting
plate.
\
[_ Rotate front of
o_en
up against cabinet
bottoI//.