GE JVM1600 Series Installation Instructions Manual page 19

Installation Instructions
RECIRCULATING
(Non-Vented Ductless)
INSTALLATION OVERVIEW
C1. Attach Mounting Plate to _'all
C2. Prepare Top Cabinet
C3. Adjust Blower
C4. Mount the Oven
C5. Install Charcoal Filter
/// ////
I-_ ATTACH THE MOUNTING
PLATE TO THE WALL
Attach the plate to the wall using toggle bolts. At
least one wood screw i/lust be used to attach the
plate to a wall sttld.
_ Remove the toggle wings fl'om the bolts.
_ Insert the bolts into the mounting plate through
the holes designated to go into dr}svall and
reattach the toggle wings to :Y," onto each bolt.
To use toggle bolts:
Spacing for Toggles
MoreThanWall
+l_H,-!._Thickness
Wings
Mounting
Plate
Bolt End
_ Place the mounting plate against the wall and
insert the toggle wings into the holes in the wall to
mount the plate.
NOTE: Betore tightening toggle bolts and wood
scre_, make sure the tabs on the mounting plate
touch the bottom of the cabinet when pushed flush
against the wall and that the plate is properly
centered under the cabinet,
CAUTION: Be careflfl to axoid I)inching, fingers,
between the back of the mounting plate and the wall.
_ Tighten all bolts. Pull the plate away from the wall
to hel I) tighten the bolts.
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes fl)r the top sui)port screws and
a hole large enouoh for the power cord to fit throuoh
" Read the instructions on the TOP CABINET
TEMPI,ATE.
" Tape it underneath the top cabinet.
" Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes
in the cabinet bottom.
19