Outside Back Exhaust; Back Exhaust - GE JVM1600 Series Installation Instructions Manual

Installation Instructions
ADAPTING BLOWER FOR
OUTSIDE BACK EXHAUST
_ Remove the two screws that hold the blower plate
and remove the screw holding the blower motor
to the oven. Slide blower plate fl'om trader its
retaining flange.
Retaining _ _
H0n0
[] Careflflly the blower trait. The wires pull
O[lt
will extend e_r enough to allow you to a(!just
the blower unit.
BEFORE: Fan Blade
Openings Facing Up
_,_ Back of
Oven
[]Rotate blower trait counterclockwise 180 °.
BeforeRotation After Rotation
Backof
Oven
Backof
Oven
[]Roll the blower trait 90 ° so that tan blade
openings are lacing otlt the back of the
Backof
Oven
o_, eI1.
BeforeRolling After Rolling_
Backof
Oven
[]
i,ocate the two "knockout" plates, on the rear
oven panel, near the top of the oven.
Using tin snips, carefldly cut the web area fl'om
the two holes side-by-side (that secure the
knockouts to tile oven). Cut all fimr webs on
both rear knockouts; this will allow the
ventilation tan airflow to exhaust out the
rear of the oven.
CAUTION: Be sure to trim the sharp edges from
the openings after removing the knockout plates.
Oven Rear Panel
Snipall 4webs
on eachknockout
ove
the metalknockouts
for rearairflow.
[]Place tile blower unit back into the )enin o
AFTER: Fan
Blade Openings
Facing Back
CAUTION: Do not pull or stretch the blower
refit wiring. Make sure the wires axe not pinched.
NOTE: The blower unit exhaust opmfings should
match exhaust opmfings on rear of oven.
] Replace the blower plate in tile same position
as before and replace the screws for the
blower plate and blower motor.
BlowerPlateScrews
BlowerPlate
./
__ Backof Oven
BlowerMotor Screw
17