Outside Back Exhaust - GE JVM1600 Series Installation Instructions Manual

Installation Instructions
OUTSIDE BACK EXHAUST
(Horizontal Duct)
INSTALLATION OVERVIEW
B1. Prepare Rear Wall
B2. Attach Exhaust Adaptor to
Wall Plate
B3, Attach Mounting Plate
to X,Vfll
B4. Prepare Top Cabinet
BS. Ac!iust Blower
B6. Mount the Oven
5
I-_ PREPARING THE REAR WALL
FOR OUTSIDE BACK EXHAUST
_ Place the motmting plate against the rear wall and
align it with the holes drilled earlier.
[] Using a pencil, put clots through holes/notches K
G, H and ] (see above ilhlstration). Remove the
motmting plate and draw lines extending through
the points. This will give the location and size of the
box cutout fin" the rear wall duct.
[] Use a saw (saber or keyhole) to cut out the opening.
ATTACH THE EXHAUST
ADAPTOR TO THE WALL PLATE
[_ Insert the tabs on each side of the damper into
the holes at the inside rear of the adaptor.
1
i__.__ Exhaust
Adaptor
[]Atta c h t h e exh a tlst a da ptor to the ba c k of the
wall plate by sliding it into the gtfides at the top
center of the back of the plate.
Exhaust Adaptor
_ _ Damper
Slide exhaust /_ __5 (hinge side uP)
adaptor into
_[_/ __
guides on
wo,, p,ate.
__ _Guide
Guide _ Locking
0 0 Tabs
Push in secm'elx tmtil it is in the lower locking tabs.
Take care to assm'e the damper hinge is installed so
that it is at the top and that the damper ,swin,,s_,freely,
15