Determining _All Plate Loration - GE JVM1600 Series Installation Instructions Manual

Installation Instructions
DETERMINING WALL PLATE LOCATION UNDER YOUR CABINET
Plate position - beneath flat bottom
cabinet
Plate position - beneath framed recessed
cabinet bottom
Mounting Plate Tabs
! the Cabinet
Bottom
""S,
At least 30", up to 36"
Mounting Plate Tabs
Touching the Bacl<
Frame
\
\
\
!
30" to Cool<top
Plate position - beneath recessed bottom
cabinet with front overhang
Mounting Plate with
Tabs Below Cabinet
Bottom the Same
Distance as the Front
Overhang Depth
, II
30"to Cool<top
Your
cabinets may have decorative trim that interferes
with the oven installation. Remove the decorative trim
to install the oven properly and to make it level.
THE OVEN MUST BE LEVEL
Use a level to make sure the cabinet bottom is level.
If the cabinets have a fl'ont overhang only, with no
back or side fi'ame, install the mounting plate down
the same distance as the fi'ont overhang depth. This
will keep the oven level.
[]Measure the inside depth of the fi'ont overhang.
[] Draw a horizontal line on the back wall an equal
distance below the cabinet bottom as the inside
depth of the fi'ont overhang.
_For this b'pe of installation with fl'ont overhang only,
align the mounting tabs with this horizontal line, not
touching the cabinet bottom as described in Step D.
9