[] ()Utside Top Exhaust; Attach Mounting Plate To - GE JVM1600 Series Installation Instructions Manual

Installation Instructions
OUTSIDE TOP EXHAUST
(Vertical Duct)
INSTALLATION OVERVIEW
A1. Attach Mounting Plate to Wall
A2. Prepare Top Cabinet
A3. Install Adapter
A4, Mount Oven
A5. Ac!j ust Exhaust Adaptor
A6. Connect Ductwork
I-_ ATTACH THE MOUNTING
PLATE TO THE WALL
Attach the plate to the wall using toggle bolts. At least
one wood screw must be used to attach the plate to a
wall stud.
[]Remove the toggle wings fl'om the bolts.
[]Insert the bolts into the mounting plate
through the holes designated to go into drwvall
and reattach the toggle wings to '_A"onto each bolt.
To use toggle bolts:
Spacingfor Toggles
MoreThanWall
+l.-,-[._Thickness
Mounting
Plate
Bolt End
_ Place the mounting plate against the wall and
insert the toggle wings into the holes in the wall to
mount the plate.
NOTE: Betore tightening toggle bolts and wood
scre_, make sure the tabs on the mounting plate
touch the bottom of the cabinet when pushed
flush against the wall and that the plate is properly
centered under the cabinet.
CAUTION: Be careflfl to axoid I)inchin'*_ fingers
between the back of the mounting plate and the wall.
_ Tighten all bolts. Pull the plate awax from the wall
to hel I) tighten the bolts.
12