GE JVM1600 Series Installation Instructions Manual page 17

Installation Instructions
ADAPTING BLOWER FOR
OUTSIDE BACK EXHAUST
[] Renmve the two screws that hold the blower plate
and remove the screw holding the blower motor
to the oven. Slide blower plate fl'om trader its
retaining flange.
Retaining 1_ _
Flange ,_,4k _,___.._.._ Blower Plate
--_
[] Careflflly the blower trait. The wires pull O[lt
will extend far enough to allow you to a(!just
the blower unit.
Back of
Oven
_ Rotate blower trait counterclockwise 180 °.
Before Rotation
Back of
Oven
After Rotation
Back of
Oven
_Roll the blower trait 90 ° so that tan blade
openings are facing ot/t the back of the
o_, eIl.
Before Rolling --_ After Rolling _
ack o f
_ " Oven
t o °
Back of
Oven
_17
_] Place the 1)lox_er unit back into the opening.
CAUTION: Do not pull or stretch the blower
refit wiring. Make sure the wires axe not pinched.
NOTE: The blower unit exhaust openhlgs should
match exhaust openh_gs on rear of oven.
] Replace the blower plate in the same position
as before and replace the screws for the
blower plate and blower motor.
BlowerPlateScrews
BlowerPlate
.,_ Backof Oven
BlowerMotor Screw