System Control Panel
The generator control panel, located inside the generator
housing, is shown below.
Brief descriptions of the controls used during installation are:
The generator control board, located inside the generator,
under the roof, is shown below. Brief descriptions of the
controls used during installation are:
A o Menu/Programming Navigation Battens -- See Menu
section for details
2 o Mini US2 Port -- Authorized DealerService Use Only
C oE;eneraterOperatienCentral 2u_ans
°"AUTO" Normal operating position_ Press and hold
button to put unit into Automatic mode. if an utility
power outage is sensed, the system will start the
generator_When utility power is restored, auto lets the
engine stabilize internal temperatures, shuts off the
generator, and waits for the next utility outage.
°"OFF" Turns off running generator, prevents unit from
starting, and resets any detectedfaults_
OFFmust be pressed and held for more than 5 seconds
in order to reset service codes.
o"NiANUAL" Usedto manually start the generator.
"AUTO" LED_ LEDwill light when unit is placed into
Auto mode_ LEDwill blink if exercisecycle is not set or
set to OFF.
D - 15 Amp Fuse _ Protects the home generator DC
control circuits_ if the fuse has 'blown' (melted open) or
was removed, the engine cannot crank or start_Replace
the fuse using only an identical ATO15A fuse. One
spare fuse is supplied with the uniL
E o Caret _ This protective cover must be opened to access
the fuse and the USB port_
F o I}igitai I}ispiay -- Displays generator mode, menu
options, service codes, and service engine indicators
More information may be found in Controls in the
operator's manual,
®
(9
26