Level Range; Check Operation - Amana AEP222VAW0 Installation Instructions Manual

20" (50.8 cm) freestanding electric range with standard clean oven
Hide thumbs Also See for AEP222VAW0:
Table of Contents

Advertisement

Available languages

Available languages

1. Make sure the anti-tip bracket is installed:
Look for the anti-tip bracket securely attached to the floor.
Slide the range back so the rear range foot is under the anti-
tip bracket.
1.
Place rack in oven.
2. Place level on rack and check levelness of range, first side to
side; then front to back.
3. If range is not level, pull range forward until rear leveling leg is
removed from the anti-tip bracket.
4. Use 3/8"drive ratchet and slip-joint pliers to adjust leveling
legs up or down until range is level.
5. Push range back into position.
6. Check that rear leveling leg is engaged in anti-tip bracket.
NOTE: Range must be level for satisfactory
baking performance.
Co s: p@® n
GS on
1. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2. Check that you have all of your tools.
3. Dispose of/recycle all packaging materials.
4. Check that the range is level. See "Level Range."
5. Use a mild solution of liquid household cleaner and warm
water to remove waxy residue caused by shipping material.
Dry thoroughly with a soft cloth.
6. For range use and cleaning, read the range Use and Care
Guide.
7. Turn on surface burners and oven.
If range does not operate, check the following:
Household fuse is intact and tight; or circuit breaker has not
tripped.
Electrical supply is connected.
See "Troubleshooting"
in the Use and Care Guide.
Check the operation of the cooktop elements:
1. Push in and turn each surface element control knob to "HI"
position.
Check the operation of the cooktop elements and indicator
lights.
A
oo
_T
REAR
SURFACE
A. Surface indicator light
2. Turn the control knob to the "OFF" position.
Check operation
of the oven elements:
1. Set the oven temperature control to 350°R
The bottom element should glow red and the "OVEN ON"
indicator light should be on. The upper element should
become hot but not glow red. The "OVEN ON" indicator light
goes off when the oven is preheated.
A. Oven indicator light
2=
Set the oven temperature
control to "BROIL."
The upper element should glow red and the "OVEN ON"
indicator light should be on.
I
@
OVENTEMP
3. Turn the control knob to the "OFF" position.
12

Advertisement

Table of Contents
loading

This manual is also suitable for:

Aep200vaw0Tep200vaq0Ce11000vav0Tep222vaq0Tep222vab0

Table of Contents