Amana AEP222VAW0 Installation Instructions Manual page 7

Power Supply Cord Direct Wire
Electrical Shock Hazard
Disconnect power before servicing.
Use a new 40 amp power supply cord.
Plug into a grounded outlet.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Electrical Shock Hazard
Disconnect power before servicing.
Use 8 gauge copper or 6 gauge aluminum wire.
Electrically ground range.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1=
2.
3.
Disconnect power
Remove the terminal block cover screws located on the back
of the range. Pull cover down and toward you to remove
cover.
o
A. Hold-down screws
B. Terminal block cover
Add strain relief.
Style 1: Power supply cord strain relief
• Assemble a UL listed strain relief in the opening.
B
A. UL listed strain relief - large opening
B. Small opening
• Feed the power supply cord through the strain relief on
the cord/conduit plate on bottom of range. Allow enough
slack to easily attach the wiring to the terminal block.
• Tighten strain relief screw against the power supply cord.
Style 2: Direct wire strain relief
• Use Phillips screwdriver to remove screws and rotate/
conduit plate 180°.
A
A. Large opening
B. Small opening
Position cord/conduit plate as shown in the following
illustration.
A. Small opening
B. Large opening