Table of Contents
Advertisement
Operating position
Before moving
range across floor, check
that range is still on cardboard
shipping
base to protect floor covering.
7[]
Make
sure
the anti-tip
bracket
is
installed:
Look for the anti-tip
bracket securely
attached to floor.
Slide range back so rear range foot
is under anti-tip
bracket.
8[]
If installing
the range in a mobile
home, you must secure the range to the
floor. Any method
of securing
the range
is adequate
as long as it conforms
to the
standards
in the "Mobile
home
installation"section.
9_
Place rack in oven. Place level on
rack, first side to side; then front to back.
If range
is not level,
pull range
forward
until
rear
leveling
leg is removed
from
the anti4ip
bracket.
Use 3/8" drive
ratchet
and channel
lock pliers
to adjust
leveling
legs
up or down
until
range
is level.
Push
range
back into
position.
Check that
rear
leveling
leg is engaged
in anti4ip
bracket.
NOTE: Oven must be level for
satisfactory
baking conditions,
Replace the storage drawer
or
lower panel.
1_
Reconnect
power.
Check operation
2_
Check the operation
of the
cooktop
elements:
Push in and turn each surface unit control
knob to "Hi"
position.
Check the
operation
of the cooktop
elements
and
indicator
lights.
CO
FRONT
OFF
@O
3_
Check the operation
of the
oven:
If your oven has one of the two types of
electronic
controls
shown:
Press the "BAKE"
pad.
Depending
on model, the "BAKE"
and "TEMP"
indicators
will light
and "350" will appear in the display
or, the "BAKE"
indicator
will light
and "350" will appear in the display.
2_
_The "START"
indicator
will begin
flashing
after 5 seconds.
Press the "START/ENTER"
pa&
_The "ON" indicator
will light.
_The "TEMP"
indicator
will turn off.
*The
display
wiii
show
the automatic
countdown
time
needed
to preheat
the oven
to the selected
temperature
("350")
and begin
counting
down.
oThe
bottom
element
should
glow
red_
_The upper element
should
become
hot, but not glow red.
3.
Press the "OFF/CANCEL'
pad.
NOTE:The
oven will not go through
preheat
if the oven temperature
is above
170 ° F; instead, the "TEMP"
indicator
will
light and the selected temperature
will
appear in the display.
4.
Press the "CUSTOM
BROIL' pa&
* Depending
on model, the "BROIL'
and "TEMP"
indicators
will light
and "500"
will appear in the display
or, the "BROIL'
indicator
will light
and "500"
will appear in the display.
_The "START"
indicator
will begin
flashing
after 5 seconds,
5.
Press the "START/ENTER"
pad.
®The "ON" indicator
will light.
_The upper element
will glow re&
6.
Press the "OFF/CANCEL'
pad.
You have just finished
installing
your
new range.To
get the
most
efficient
use from
your
range,
read your
Use & Care
Guide.
Keep Installation
Instructions
and Guide
close to
range for easy reference.
The
instructions
will
make installing
the range
in another
home
as
easy as the first
installation.
Advertisement
Table of Contents
